Gas wall furnaces are a popular choice for many homeowners and property managers. They can also be very efficient, but they can be expensive. As with any furnaces, installation requires proper preparation.
A gas wall furnace from Airware Sales does not use wood pellets as a fuel source, so there is no need to line the chimney with logs or soil. A unit that uses wood chips is also not necessary, because wood chips do not combust.
Installation of a gas-fired unit will require the use of special tools. A system that attaches directly to the main heating system is more efficient than a system that is attached to the stove or sink. Also, to keep the unit cool in hot weather, a separate cooling fan must be installed. You should remove the water from the furnace vent pipe before installation.
Generally, it is easy to install gas wall furnaces; however, it may take a little planning. It is essential to make sure that the furnace has a properly sized flue, especially if your home has unusual heights. The problem with tall dwellings is that the pipes can become jammed up due to their height.
Before installation, it is recommended that the flue is widened by at least 2 inches. It would be best if you also planned on installing an exhaust fan on the main vent line. It is also essential to check to make sure that the unit will fit in the same manner as it would if it were the same model as the one you currently have.
You will have to set the gas valve for the furnace, a pump to turn the gas valve on and off, and a gas manifold in the furnace and hook it up correctly. The gas supply to the unit should also be flowing through a pipeline to a pipeline so that it does not leak out when you are not using it. Moreover, if you have a newly installed furnace, it will have a regulator to control the pressure.
If you live in a townhouse or condominium, your homeowner’s association may have certain restrictions on how you install your unit. You may need to contact the HOA and ask about installation guidelines. If you live in a condominium, you may be required to remove items such as the freezer or refrigerator from the unit to prevent damage to the unit.
Installation of a gas wall furnace from Airware Sales s not particularly tricky, but it does require some attention. One thing to be aware of is that the temperature of the gas in the furnace will change as the unit runs. It will cause the thermostat to adjust accordingly.
The fixture needs to be replaced after it is installed. It is usually easy, but you may need to remove some insulation or caulking from the electrical connections before you replace the circuit breaker. With a gas wall furnace, a new thermostat is located somewhere near the top of the furnace.
If you have a new thermostat and are having trouble with it, call the manufacturer. The warranty may be invalidated if there is a fault with the thermostat. You should also make sure that you use the correct electrical plugs to connect the new unit to the primary circuit.